Moteck SG-2100 dish motor can move the satellite dish from east to west to track the satellites postioned along the Clarke belt. This motor can move dish up to 120cm, letting you watch the world of free to air MPEG2 channels. Easy to install, the SG-2100 motor features a 1 5/8" masthead and points downward.
Moteck SG-2100 works for any offset dish with a U-bolt or Pole mounting up to 120 cm Aluminum or 95 cm Steel. This motor will fit a Winegard 30" dish and FortecStar dishes.
Works with all DiSEqC 1.2, 1.3, Goto X compliant satellite receivers. It utilizes a data stream passed up the LNB co-axial lead to the mount. Only one co-axial cable is needed for installation.
Fits all popular dish with 42mm tube, including Winegard
Special Design for any Receiver with DiSEqC 1.2
Only One Coaxial Cable Control
Go To X Function
Ultra Low Noise
Adjustable Hardware Limits
Easy Installation with LED Indicator
Manual EAST / WEST button
For Dish up to 1.2M
Antenna Diameter 1.2M Max.
Length of Motor Tube 18cm
Azimuth Angle 75EAST ~ 75?WEST ( 150? ) Adjustable
Elevation Angle 10?~75?
Input / Output Voltage 13 / 18 VDC
Power Consumption 50 mA ( Standby mode )
200mA ( Normal)
350 mA ( Max.)
Rotation Speed 1.9? / sec ( at 13V) ; 2.5 ?/ sec ( at 18V)
Satellite Positions 60
Connector F Type
Command Protocol DiSEqC 1.2
Resynchronize Function YES
Goto Position 0 Function YES
Goto X Function YES
Positioning Sensor Hall Effect Sensor
EAST / WEST Limit Adjustable Hardware and Programmable Software
Manual Button EAST / WEST